Skip to content
OneSource Integration LLC

Winter closer season Cold slows closers and stiffens weatherstripping. A slamming door needs adjusting. More →

Services

Hinges and pivots — where sagging doors start.

When a door drags the floor, binds in the frame, or misses its latch, the frame usually takes the blame. It's almost always the hinges. Fixing the hinge fixes the door, and it's routinely the least expensive repair on an opening. Serving commercial buildings across Central New York.

What This Covers

Hinge Repair & Replacement

Worn, squealing, and sagging hinges replaced with correctly sized butt hinges — and stripped screw holes properly repaired, because new hinges in old holes won't hold any better than the ones that just came out. Doors with closers should be hung on ball-bearing hinges; plain-bearing hinges wear out fast under a closer's load. Fire-rated doors need hinges that meet the door's listing — typically steel ball-bearing hinges.

Heavy-Duty & Continuous Hinges

High-traffic doors need hinges that spread the load along the full height. Continuous hinges end the sag-adjust-sag cycle on schools, storefronts, and busy service doors, and usually pay for themselves in avoided callbacks.

Pivots

Offset and center-hung pivots for storefront and heavy doors, including floor closers. When a heavy door starts grinding, dropping, or swinging out of true, the pivot is carrying more load than anything else on the opening. I work with Hager, McKinney, Ives, Stanley, Rixson, and other manufacturers.

The door isn't warped. The hinges are worn.

Hinge wear is gradual, so buildings live with a dragging door for years and adapt around it. It's worth catching early, because the end state is a door that won't close at all — and by then the frame has usually taken damage too.

Symptoms Worth a Second Look

Questions About Hinges & Pivots

Is the door warped, or is it the hinges?

Almost always the hinges. Worn knuckles and loose screws let the door drop on the latch side, which looks like a warped door.

Uneven gaps around the door are the giveaway.

Why do hinge screws keep working loose?

Usually because the holes are stripped. New screws in old holes don't hold.

The holes need to be repaired properly, or the hinge needs through-bolts or longer screws into solid material.

When does a continuous hinge make sense?

On heavy, high-traffic doors that keep sagging even after hinge replacement — school entrances, storefronts, busy service doors.

It spreads the load along the full height of the door and ends the repeat calls.

Can a door with a closer use standard hinges?

It shouldn't. A closer puts constant load on the hinges. Ball-bearing hinges are the standard for any door with a closer.

All questions

Something here sound familiar?

Tell me what the opening is doing and what building it's in. A free 15-minute phone consult is often enough to tell what you're dealing with. For a full assessment, the door, frame, and hardware are looked at together, with the findings in writing.