Access control, from the door side.
Electrified hardware and access control from the door side: power supplies, transfer, lock selection, and how the opening behaves on fire alarm and on loss of power. Specification and troubleshooting — not panel programming, which is someone else's trade and usually already covered. Serving commercial buildings across Central New York.
What This Covers
Lock & Strike Selection
Which device suits the door, the frame, and the traffic, and whether it should be fail-safe or fail-secure. That last question is a code decision driven by the occupancy and the egress path, not a preference, and it's settled at specification or not at all. On fire-rated doors, the lock or strike has to keep the door latched when power is lost — fail-secure — because a fire door has to latch. I work with HES, Von Duprin, Securitron, Schlage, and other electrified hardware manufacturers.
Power & Transfer
Power supplies sized for the load, and getting current across a moving joint — hinges, transfer devices, loops. Many intermittent access control faults are a transfer that's been flexing for several years and is now failing under the door's own movement.
Fire Alarm & Power Loss
What the opening does when the alarm sounds and when the power drops. These are the conditions the system will be judged on and the least often tested, because testing them means deliberately failing the building on a quiet afternoon.
The reader says yes. The door still has to open.
Access control is only as good as the hardware it's wired to. The credential side is usually well served; the door side is where specification gaps and intermittent faults pile up, and it's the side that determines whether anyone actually gets through.
Symptoms Worth a Second Look
- The reader accepts the credential but the door won't open
- It releases but doesn't relatch
- New access control needs hardware specified for it
- Fail-safe versus fail-secure was never decided
- Nobody has tested what happens on fire alarm
- The fault is intermittent and blamed on the panel
- A retrofit has to work with existing doors and frames
- The hardware and the access system were specified separately
Questions About Access Control
- Fail-safe or fail-secure — which do we need?
It depends on the door. Fail-safe unlocks when power is lost; fail-secure stays locked from the outside.
Fire doors need to stay latched, so their electrified hardware is fail-secure. Free egress from inside is required either way.
- Are magnetic locks allowed on exit doors?
In limited cases, with conditions: a sensor that releases the lock as someone approaches, a manual release button, and release on fire alarm and power loss.
They're often the wrong choice where a properly specified electrified lock or strike would do.
- The reader beeps green but the door doesn't open. Why?
Usually the lock released but the latch is bound against the strike, or the power transfer through the hinge has failed. Both are door-side problems.
- Do you program access control panels?
The focus is the opening: the lock, strike, power, and transfer.
I work alongside whoever runs the panel so the door and the system behave the same way.
Related
Keypad & Electronic Locks
Standalone code and credential locks.
Panic Hardware & Exit Devices
Electric latch retraction.
Field Troubleshooting
When the fault won't stay put.
Electronic Door Hardware Articles
Strikes, mag locks, fail-safe and fail-secure.
Brands I Work With
HES, Von Duprin, Securitron, Schlage, and others.
Something here sound familiar?
Tell me what the opening is doing and what building it's in. A free 15-minute phone consult is often enough to tell what you're dealing with. For a full assessment, the door, frame, and hardware are looked at together, with the findings in writing.